Before you start, prepare your work area. Good lighting and a clean, spacious surface will allow you to work more efficiently and avoid damaging your wall art.

Allow the surface to dry completely after cleaning (approximately 2 minutes). A perfectly clean and dry surface ensures maximum adhesion and extends the lifespan of your installation.

Use a pencil to lightly mark the positions before permanently applying the adhesive plates. You can easily erase these marks afterwards.

Ideally, place your wall art at eye level (approximately 1.60m from the floor to the center of the artwork). For reception areas, slightly lower placement creates a more intimate and welcoming atmosphere.

Use painter's tape to temporarily mark the positions on the wall. This allows you to check alignment before drilling and adjust if needed.

• For plaster or lightweight partition walls: use special drywall anchors if the wall is fragile.
• For concrete walls: drill slightly deeper than the plug length.
• For brick walls: avoid drilling into the mortar joints between bricks.

Once your wall art is hung, use a spirit level to check that it is perfectly straight. Make minor adjustments if necessary by adjusting the hook positions.