Assembly instructions

For smooth walls (no need to use screws and dowels)

For small and medium sizes

  1. Choose where you want to hang the painting.
  2. Take a level, then make light pencil marks as a guide.
  3. Open the box and remove the films from one side of the double-sided adhesive strips.
  4. Glue the strips to the 4 corners of the board (about 15 cm from the edges).
  5. Remove the films from the other side of the headbands.
  6. Place one edge of the board near the marked lines to straighten it.
  7. Once it is straight and well placed, stick it to the wall.
  8. Press down on the strips so that they are firmly stuck.

For large sizes

At least two people are needed to hang it.

  1. Choose where you want to hang the painting.
  2. Take a level, then make light pencil marks as a guide.
  3. Open the box and remove the films from one side of the double-sided adhesive strips.
  4. Glue the strips in rows of 3 along the entire length, as shown below.
  5. Remove the films from the other side of the headbands.
  6. Place one edge of the board near the marks you made to straighten it.
  7. Once it is straight and well placed, stick it to the wall.
  8. Press down on the strips so that they are firmly stuck.

For uneven and rough walls, use screw and dowel reinforcements

For small and medium sizes

  1. Choose where you want to hang the painting.
  2. Take a level, then make light pencil marks as a guide.
  3. Drill holes in the wall where your marks are.
  4. Place the dowels inside.
  5. Overlap the pre-drilled half strips over the dowels and screw through.
  6. Once the half strips are securely fixed to the wall, place the second half on top and clip it.
  7. Remove the plastic film.
  8. Place the board on the wall near the adhesive strips.
  9. Once you are sure it is straight, stick it to the wall.
  10. Press firmly on the strips so that they are well stuck.

For large sizes

At least two people are needed to hang it.

  1. Choose where you want to hang the painting.
  2. Take a level, then make light pencil marks as a guide.
  3. Drill holes in the wall where your marks are.
  4. Place the dowels inside.
  5. Overlap the pre-drilled half strips over the dowels and screw through.
  6. Once the half strips are securely fixed to the wall, place the second half on top and clip it.
  7. Remove the plastic film.
  8. Place the board on the wall near the adhesive strips.
  9. Once you are sure it is straight, stick it to the wall.
  10. Press firmly on the strips so that they are well stuck.